Basic Boat Info
Dimensions
Engines / Speed
- Make: Caterpillar
- Model: 3208
- Fuel: Diesel
- Engine Power: 435hp
- Type: Inboard
- Year: 1998
- Engine Hours: 3375
- Engine Location: Port
- Make: Caterpillar
- Model: 3208
- Fuel: Diesel
- Engine Power: 435hp
- Type: Inboard
- Year: 1998
- Engine Hours: 3355
- Engine Location: Starboard
Tanks
Other
Repairs and Maintenance
August 2022
- All injectors were replaced in both engines.
- Two in-take Turbo – dismantled, serviced, and installed.
- Replaced all after coolers.
- The valve calibration of both engines was removed and replaced.
- (4) new Gasket for valve cover.
- (2) new Gasket for Turbo ducks.
- Oil and air filters were changed in both engines.
- Zincs pencils were changed in both engines.
- Transmission fluid was changed in both engines.
- Installed (4) Racor 2040/10 Micron filters.
- (10) Zinc pencils with caps.
- (4) Filters for oil 1R 0714
- (2) Filters for diesel 1R0750
- (2) Cartridge Air filters
February 2023
- Installed all new white sanitation hose.
- Replaced float switch and wires. New Rul 35 Float switch.
- Rebuild vacuflush tank.
- Installed new overboard pump.New Pump TW12 OEM Discharge.
- Installed new vent filter.
- Clean the engine room and storage area.
- Replaced bellows.
- Vacuum generator pressure switch replaced.New Kit Vacuum Tank switch-VGII
- Installed new head base.New Kit 506/806/1006/706 Base Bone
- Installed Steering rod.
- New Sealant “Eco” Vent filter.
- New Kit TPump Conv S to W 12vdc
March 2023
- Installed new 8D battery generator.
- Installed new pressure gauge on steering reservoir.
- Serviced the Simrad Electronics
- Installed new battery straps for stbd and port batteries.
- Installed new battery box for generator battery.
April 2023
- Installed new steps.
- Installed (2) 2” new valves, thru hull fittings.
- Removed and cleaned all rudders and re-did packing.
- Installed rudders and steering.
- Install all the screens.
- Install (4) cutlass bearings.
- Install new shaft seals.
- Removed and Installed props.
- Resealed bonding struts.
- Install trim tab motor.
- Aligned port engine.
May 2023
- Install new roll pin.
- Fabricate 7 new non-skid steps.
June 2023
- Purchase new 50-amp 125/250 Marinco cord.
- Rebuild engine room bulkhead.
July 2023
- Mounted engine room ladder with carriage bolts.
- Mounted port and stbd racor filter aft bulkhead.
The Company offers the details of this vessel in good faith but cannot guarantee or warrant the accuracy of this information nor warrant the condition of the vessel. A buyer should instruct his agents, or his surveyors, to investigate such details as the buyer desires validated. This vessel is offered subject to prior sale, price change, or withdrawal without notice.